Spring knowledge
Sep 19, 2023| What is the basis of spring design?
Type I: capable of withstanding 106 times of alternating load;
Type II: capable of withstanding 103-105 times of alternating load;
Type III: capable of withstanding less than 103 times of alternating load;
2. The width thickness ratio (Ab) of the material should not be too large, Spring The winding of should not be too small.
3. When designing non rectangular springs with special sections, it is necessary to derive different rotation ratios, different width thickness ratios, and deformation correction factors τ And shear stress correction factor β Lower curve or calculation formula.
4. According to the given and limited conditions, select a design method that is simple in calculation and reasonable in parameter selection.
5. The above is a brief introduction to the spring stress relief tempering shrinkage technology, which is widely used by spring enterprises because of its efficacy!
Previous: Common problems and solutions of electroplated spring